Marisa Di Sabatino
Marisa Di Sabatino
Verified email at
Cited by
Cited by
Light-induced boron-oxygen defect generation in compensated -type Czochralski silicon
D Macdonald, F Rougieux, A Cuevas, B Lim, J Schmidt, M Di Sabatino, ...
Journal of Applied Physics 105 (9), 093704, 2009
Crystalline silicon solar module technology: Towards the 1€ per watt‐peak goal
C Del Canizo, G Del Coso, WC Sinke
Progress in photovoltaics: research and applications 17 (3), 199-209, 2009
Degassing, hydrogen and porosity phenomena in A356
D Dispinar, S Akhtar, A Nordmark, M Di Sabatino, L Arnberg
Materials Science and Engineering: A 527 (16-17), 3719-3725, 2010
Distribution of iron in multicrystalline silicon ingots
R Kvande, LJ Geerligs, G Coletti, L Arnberg, M Di Sabatino, EJ Øvrelid, ...
Journal of applied physics 104 (6), 064905, 2008
A review on the fluidity of Al based alloys
M Di Sabatino, L Arnberg
Metallurgical Science and Tecnology 22 (1), 2004
The influence of oxide inclusions on the fluidity of Al–7 wt.% Si alloy
M Di Sabatino, L Arnberg, S Rørvik, A Prestmo
Materials Science and Engineering: A 413, 272-276, 2005
Determination of relative sensitivity factors for trace element analysis of solar cell silicon by fast-flow glow discharge mass spectrometry
M Di Sabatino, AL Dons, J Hinrichs, L Arnberg
Spectrochimica Acta Part B: Atomic Spectroscopy 66 (2), 144-148, 2011
Fluidity of aluminium foundry alloys
M Di Sabatino
Fakultet for naturvitenskap og teknologi, 2005
An improved method for fluidity measurement by gravity casting of spirals in sand moulds
M Di Sabatino, F Syvertsen, L Arnberg, A Nordmark
International Journal of Cast Metals Research 18 (1), 59-62, 2005
Electrical fragmentation as a novel route for the refinement of quartz raw materials for trace mineral impurities
E Dal Martello, S Bernardis, RB Larsen, G Tranell, M Di Sabatino, ...
Powder technology 224, 209-216, 2012
In situ investigation of spinodal decomposition in hypermonotectic Al–Bi and Al–Bi–Zn alloys
PL Schaffer, RH Mathiesen, L Arnberg, M Di Sabatino, A Snigirev
New Journal of Physics 10 (5), 053001, 2008
Castability of aluminium alloys
M Di Sabatino, L Arnberg
Transactions of The Indian Institute of Metals 62 (4-5), 321-325, 2009
Oxygen distribution on a multicrystalline silicon ingot grown from upgraded metallurgical silicon
M Di Sabatino, S Binetti, J Libal, M Acciarri, H Nordmark, EJ Øvrelid
Solar energy materials and solar cells 95 (2), 529-533, 2011
State-of-the-art growth of silicon for PV applications
L Arnberg, M Di Sabatino, EJ Øvrelid
Journal of crystal growth 360, 56-60, 2012
Study of defects and impurities in multicrystalline silicon grown from metallurgical silicon feedstock
S Binetti, J Libal, M Acciarri, M Di Sabatino, H Nordmark, EJ Øvrelid, ...
Materials Science and Engineering: B 159, 274-277, 2009
Fluidity evaluation methods for Al–Mg–Si alloys
M Di Sabatino, L Arnberg, S Brusethaug, D Apelian
International Journal of Cast Metals Research 19 (2), 94-97, 2006
Effect of grain refinement and dissolved hydrogen on the fluidity of A356 alloy
M Di Sabatino, L Arnberg
International Journal of Cast Metals Research 18 (3), 181-186, 2005
Impact of growth rate on impurities segregation at grain boundaries in silicon during Bridgman growth
A Autruffe, L Vines, L Arnberg, M Di Sabatino
Journal of crystal growth 372, 180-188, 2013
Defect generation, advanced crystallization, and characterization methods for high‐quality solar‐cell silicon
M Di Sabatino, G Stokkan
physica status solidi (a) 210 (4), 641-648, 2013
Influence of oxide additions on the porosity development and mechanical properties of A356 aluminium alloy castings
T Ludwig, M Di Sabatino, L Arnberg, D Dispinar
International Journal of Metalcasting 6 (2), 41-50, 2012
The system can't perform the operation now. Try again later.
Articles 1–20